Additional Features
Motion-Triggered Siren
The internal 110 db Siren is triggered when the device is locked and movement is detected for more than 6 seconds. Once the siren is triggered, it will run for 30 seconds, and then automatically turn off.
The Motion-triggered siren feature can be enabled or disabled via a configurable setting on the Fleetview dashboard or in the retail mobile app. There are three available tone settings, which are demonstrated here.
Audible Tones
Audible tones can indicate the state of the lock:
Unlocking
After unlocking the lock has finished
One short beep
Locking
After locking the lock has finished
Three short beeps
Charging
When pogo charger is connected
Two short beeps - low/high
Cap sense press
When cap touch is pressed
One short beep
Tether
When tether is inserted, indicates the tether is attached
When unlocking the lock, indicates the tether is released
After unlocked, indicates the tether is still attached even though it has been released. This tone repeats every 10 seconds until the tether has been detached.
Three short beeps - low/mid/high
Error
Stall event - When locking the device, but locking ring hits an obstruction and retracts
Movement while locking - A lock command was sent but the lock was in motion
Tether detached - After inserting the tether, the tether was detached before the locking mechanism engagement could complete
Two short beeps - high/low
Wakeup
Lock is asleep. The lock is woken up by pressing the cap touch button
Two beeps - low/high
PAC
Hold cap touch button for 4 seconds. Lock enters PAC mode with a tone - med/low/high Enter the PAC code into the lock. After each digit, a low/high tune sounds
Lock Warning
Timed auto-lock is about to be triggered. The tone sounds before locking begins
Remote Lock command is sent to the device. The tone sounds before locking begins
Seven beeps - varying length
Remote Siren
Remote command sent to device
Oscillating high-low - medium volume, 10 second duration
Motion-triggered Siren
• Audio setting selects the siren tone, if enabled
• Device is locked, and motion occurs for more than 6 seconds
• Siren will sound for 25 seconds and turn off automatically
Tone 1 - Fast oscillating siren
Tone 2 - Steady siren
Tone 3 - Slow oscillating siren
Click here to hear each of the sounds.
Sleep Timer
By default, Locks will go to sleep after 30 minutes of inactivity to improve battery performance. To awaken the Lock, either press the Multifunction button, or shake the Bike. The Sleep Timer can be adjusted in Fleetview in Settings.
LED
Cellular Connectivity and GPS Tracking
Depending on Fleet Settings, a Lock uses cellular connectivity during:
Theft Alert to send location data when locked
A Lock or Unlock event to send location and battery data
During a Periodic Ping
Constantly when in Remote Connected Mode which facilitates Remote Commands.
See the "Cellular Connectivity" article for more information.
Firmware Updates
With the Operator App connected to a Lock, go to Settings; the App will signal if the Lock needs to be updated. To update the Lock firmware, click the link and follow the on screen instructions.
Lock Reset
To reboot the device, hold the Cap Sense for 10 seconds until the LED light turns off
Last updated
