Lock / Unlock Operation
Locking and unlocking the LEO 2 can be achieved in a variety of ways:
Lock/unlock from mobile apps. These includes the LINKA retail app, LINKA GO, Operator App or the Mobile SDK. The mobile phone must be within bluetooth range of the lock. The bluetooth range of the LEO 2 is up to 10m (30 ft).
Lock/unlock remotely from Fleetview®. LEO 2 must be online and have an active cellular connection. Configure the power modes to ensure lock can stay online.
Quick lock by holding the Cap Sense for 1.5 seconds
Phoneless unlock with 4 digit Access Code **Only for Personal Use
Lock/unlock with SmartMotion Key
Automatic locking when attaching a TetherSense® security chain
Auto-lock functionality
Lock States
Unlocked
Device is unlocked. Optional single beep tone when activated.
Locked
Once locked, the device will make 3 consecutive beeps.
Locked + Tether
With a TetherSense chain attached and the Bike/Lock locked.
Unlocking/Locking
Unlocking and locking will be displayed momentarily when the
device is changing to unlocked or locked.
Stall
Displayed if the locking shackle encounters an obstruction while locking. In this state, the locking shackle will automatically retract for safety reasons.
Unlocked + Tether still connected
An Alert to Rider. TetherSense chain must be fully detached before using the bike. The device will emit a short beep every 10 seconds until the TetherSense chain is fully detached or until the device has been locked.
Quick Lock
Quick lock allows the LEO 2 to be locked even when a phone is not present. To lock the device, simply hold the Cap Sense button for 1.5 seconds.
Autolock
If enabled, the Locks will automatically self-lock after a set period, if no movement is detected. The auto-lock configuration can be set on Fleetview:
Settings > System Settings > Leo and IoT config > Auto Lock > [ value]
Note: By default, auto-lock functionality is disabled for LINKA GO usage.
Phoneless Access Code (PAC)
Phoneless Access codes allow Users to Unlock a Bike without a Smart Phone, should that be necessary. To enter an access code, press and hold the Multifunction Button until the LED turns purple, then enter the 4-digit access number by pressing the button that many times for each digit. For example: the number 4 will require four presses of the button.
To enter a phoneless access code and open a Lock:
Hold down the Control Button for 4 seconds (LED turns purple).
Enter the first digit by pressing the Multifunction Button that number of times corresponding to the first digit. (e.g. 4 presses for the number 4)
After each number is entered, wait 2 seconds before entering the next number. The LED will change color for each number to be entered.
Purple- First Digit
Red - Second Digit
Yellow - Third Digit
Green - Fourth Digit Note: If the User fails to enter the values in time, or there is no activity, the lock will exit the phoneless access code input mode after 6 seconds.
Setting Up a Phoneless Access Code
If enabled, locks will require a Phoneless Access Code be created during the Setup and pairing process in the retail app.
Stall and Spoke Evasion
The locking shackle for the LEO 2 is specially designed to allow for tolerance when the locking ring hits a spoke, and adjust its position to move around. In the event that the locking ring is unable to move around the spoke, it will trigger a "Stall" and the locking shackle will retract.
Motion Sensor to prevent locking
LEO 2 is equipped with an accelerometer to ensure the device is stationary before locking can begin.
Last updated